Warpping sheet metal
Posted: Sat Dec 31, 2022 1:06 pm
I am building a couple 1:12 scale Box cars. There is a trim piece the has a half dozen beads rolled into it.
After rollimg the beads in the piece is cut to 3 x 10. With all sort of twists. As a test I went over a test piece with a propane torch. It did not do much to flatten it out.
I have a heat treat oven which they would fit in, then. Heat and use a slow cooldown.
Thanks.
After rollimg the beads in the piece is cut to 3 x 10. With all sort of twists. As a test I went over a test piece with a propane torch. It did not do much to flatten it out.
I have a heat treat oven which they would fit in, then. Heat and use a slow cooldown.
Thanks.