Page 1 of 1
Power Models 11” Westinghouse Pump
Posted: Fri Apr 02, 2021 7:36 am
by FLtenwheeler
I just purchased the 3 molds that serviced
(survived?) the fire. I have the other 2 parts drawn up. I need to find someone that can sink the molds for me.
Thanks
Tim
Re: Power Models 11” Westinghouse Pump
Posted: Fri Apr 02, 2021 2:58 pm
by Harold_V
Doug Edwards (a board reader) is a specialist in mold making.
H
Re: Power Models 11” Westinghouse Pump
Posted: Fri Apr 02, 2021 10:41 pm
by Fender
Hard to tell what you have there. What’s inside the silver boxes?
Re: Power Models 11” Westinghouse Pump
Posted: Sat Apr 03, 2021 8:53 am
by FLtenwheeler
Fender wrote: ↑Fri Apr 02, 2021 10:41 pm
Hard to tell what you have there. What’s inside the silver boxes?
They are the 3 aluminum molds for the parts I have.
Tim
Re: Power Models 11” Westinghouse Pump
Posted: Sat Apr 03, 2021 9:33 am
by gwerhart0800
Molds to make waxes for investment casting?
Re: Power Models 11” Westinghouse Pump
Posted: Sun Apr 04, 2021 5:44 pm
by Fender
Show us the insides of the molds!
Re: Power Models 11” Westinghouse Pump
Posted: Sun Apr 04, 2021 6:44 pm
by Dick_Morris
A lot of the PMS patterns and molds were at the foundry and weren't affected by the fire. After the fire they were sold on Ebay. I have some push pole pocket and queen post patterns for sand casting from there.