Joe Pieczyniski has a good video on machining very small diameter parts in the lathe.
https://www.youtube.com/watch?v=vg6ug0FDhos
Ted
Drilling small holes
-
- Posts: 298
- Joined: Tue Jun 05, 2012 12:31 am
- Location: Sacramento, Ca.
Re: Drilling small holes
Some people raise the IQ of the room when they enter.........others when they leave.
-
- Posts: 440
- Joined: Wed May 24, 2006 8:40 am
- Location: Canandaigua, NY
- Contact:
Re: Drilling small holes
We keep our HLV fairly well aligned, but nothing NASA-like. No doubt more RPM would be nice but I bet I did them at 2000 or close. I thought it would be a disaster but was amazed at how easy it was.Harold_V wrote: ↑Wed Oct 20, 2021 3:58 pmWow! That's really impressive! The machine must have exceptional alignment, headstock to tailstock. Spells instant death for fragile cutters.Conrad_R_Hoffman wrote: ↑Wed Oct 20, 2021 3:41 pm Just recently I needed some small holes and bought some 0.0085" cobalt drill bits. They were far easier to use than I would have thought and I have little fear of going smaller, if necessary. No doubt I'd snap carbide instantly.
What speeds are at your disposal? Such a tiny drill would easily tolerate more than 10,000 rpm.
H
Conrad
1947 Logan 211 Lathe, Grizzly G1006 mill/drill, Clausing DP,
Boyar-Schultz 612H surface grinder, Sunnen hone, import
bandsaw, lots of measurement stuff, cutters, clutter & stuff.
"May the root sum of the squares of the Forces be with you."
1947 Logan 211 Lathe, Grizzly G1006 mill/drill, Clausing DP,
Boyar-Schultz 612H surface grinder, Sunnen hone, import
bandsaw, lots of measurement stuff, cutters, clutter & stuff.
"May the root sum of the squares of the Forces be with you."