Omnicut 375-P by Nu-tecsys.
I just picked up plasma cutter that is not working at this time. It’s a US built machine that is in good shape, clean etc. but is not operational except for the fan and power contactor. Doing research on line I find no info on the unit. Dose any one on this forum have the schematics to the circuit board and or general wiring for this machine? Thanks
Multis6
Omnicut 375-P
Moderator: Harold_V
Re: Omnicut 375-P
Try a search on this board for Plasma cutter - Electrical repair by EdMc posted on Feb 2003. Some info there.
Jack
Jack
Re: Omnicut 375-P
Thanks for the response. Have seen the thread, Looking for more info. thanks