new member
new member
hello all, new member here, and also new to metal lathes. i just bought a logan 1937-2 and have been practicing some. there is a lot to learn.i have an interest in firearms, and would eventually like to get into some barrel work.i was wondering what some of you who have experience in gunsmithing think about trueing the rem. 700 receiver. have you found them to be acceptable as is? i'm not thinking of benchrest accuracy, but around 1/2 inch. thanks
Re: new member
Welcome to the club! While I cannot answer your question, there are several members here who can and will. Good luck!!
Al
Al
Al Messer
"One nation, under God"
"One nation, under God"