Thanks for making these junction boxes available. I am planning to use 5/32 tubing and will need four of the boxes.
Dan
Feedback requested, PRR junction box
-
- Posts: 4
- Joined: Tue Jun 04, 2019 8:30 am
Re: Feedback requested, PRR junction box
It would be nice if you could size it down and offer it in 1" scale also.
Tim
Tim
-
- Posts: 567
- Joined: Wed Jan 07, 2004 8:04 am
- Location: Princeton, NJ
Re: Feedback requested, PRR junction box
They can be scaled to any size, and I will do that!
-
- Posts: 4
- Joined: Tue Jun 04, 2019 8:30 am
Re: Feedback requested, PRR junction box
Thank you Paul! I will be getting a few for a upcoming Pennsy project. The nice thing about Pennsylvania design locomotives is a lot of parts were interchangeable across many classes of locomotives.
-
- Posts: 567
- Joined: Wed Jan 07, 2004 8:04 am
- Location: Princeton, NJ
Re: Feedback requested, PRR junction box
One thing...in smaller sizes there might be trouble with the lettering. I can check and make sure. Yeah if you start looking at Pennsy photos those boxes are on nearly all locos!
-
- Posts: 2166
- Joined: Thu May 22, 2003 8:17 am
- Location: Bel Air, MD
Re: Feedback requested, PRR junction box
Hey Paul,
I'll look at my E6 prints and get back to you.
Andy
I'll look at my E6 prints and get back to you.
Andy
Clausing 10x24, Sheldon 12" shaper, ProtoTrak AGE-2 control cnc on a BP clone, Reed Prentice 14" x 30", Sanford MG 610 surface grinder, Kalamazoo 610 bandsaw, Hardinge HSL speed lathe, Hardinge HC chucker, Kearney and Trecker #2K plain horizontal mill, Haas TL-1 lathe.
-
- Posts: 2166
- Joined: Thu May 22, 2003 8:17 am
- Location: Bel Air, MD
Re: Feedback requested, PRR junction box
3/16"
Clausing 10x24, Sheldon 12" shaper, ProtoTrak AGE-2 control cnc on a BP clone, Reed Prentice 14" x 30", Sanford MG 610 surface grinder, Kalamazoo 610 bandsaw, Hardinge HSL speed lathe, Hardinge HC chucker, Kearney and Trecker #2K plain horizontal mill, Haas TL-1 lathe.