ISO high-quality cross slide table

Discussion on all milling machines vertical & horizontal, including but not limited to Bridgeports, Hardinge, South Bend, Clausing, Van Norman, including imports.

Moderators: GlennW, Harold_V

Post Reply
User avatar
Adirondack
Posts: 410
Joined: Tue Aug 23, 2011 6:59 pm
Location: southern CT

ISO high-quality cross slide table

Post by Adirondack »

Hi folks. I'm looking for a high-quality cross slide table that reads inches natively. It should be at least 6x18, and have a universal type mount. If it can be easily upgraded in the future to power feed/CNC, that would be a bonus.

I'm not overly concerned about country of origin, just a reasonably priced and accurate design.

Thanks!

Chris
Adirondack Car & Foundry
Check out our projects: https://www.facebook.com/ADKrail/
Visit our ALL-NEW online store: https://adirondackcarfoundry.square.site/

A little locomotive with 4 wheels on the track is a lot more fun
than a 1/2 finished one with 16 wheels on the bench!
Rich_Carlstedt
Posts: 1754
Joined: Sat Dec 21, 2002 12:16 am
Location: Green Bay Wisconsin USA
Contact:

Re: ISO high-quality cross slide table

Post by Rich_Carlstedt »

If you want high Quality, then you want a Troyke , They are the ultimate !
but not sure what sizes they have. I had a Troyke 12 x 12 years ago.. but long gone
Many Troke's also have a rotary table which was a favorite years ago before CNC .
I assume you want something like this ---never seen one like this that was high precision
https://www.ebay.com/itm/164278234948?_ ... 7023757324

Rich
Post Reply