Jet 1236P

All discussion about lathes including but not limited to: South Bend, Hardinge, Logan, Monarch, Clausing and other HSM lathes, including imports

Moderators: GlennW, Harold_V

Randydan
Posts: 9
Joined: Wed Dec 29, 2021 5:38 pm
Location: California

Re: Jet 1236P

Post by Randydan »

Bill Shields wrote: Sat Feb 05, 2022 10:02 am Good deal to be had by all.

One thing that I have learned is that a vector drive...that gives feedback to the VFD so that it knows motor rpm as well as current load...can be very helpful on a lathe there consistent surface finish is desired.
Thanks Bill, I didn't know that. I will go that route. I brought that up to Dave and he said yes, they make 2 types one with a sensor and one without. The non-sensor is now comparable in price.
User avatar
Steggy
Posts: 1976
Joined: Tue Jun 28, 2011 9:19 pm
Location: JB Pritzker’s Hellhole
Contact:

Re: Jet 1236P

Post by Steggy »

Bill Shields wrote: Sat Feb 05, 2022 7:38 am A been there done that caution on cheap 3 ph motors and low speed cogging and overheating.

Yep! As always, you'll never get more than you paid for.
———————————————————————————————————————————————————————
Music isn’t at all difficult.  All you gotta do is play the right notes at the right time!  :D
User avatar
Bill Shields
Posts: 10459
Joined: Fri Dec 21, 2007 4:57 am
Location: 39.367, -75.765
Contact:

Re: Jet 1236P

Post by Bill Shields »

BigDumbDinosaur wrote: Sat Feb 05, 2022 2:04 pm
Bill Shields wrote: Sat Feb 05, 2022 7:38 am A been there done that caution on cheap 3 ph motors and low speed cogging and overheating.

Yep! As always, you'll never get more than you paid for.
Unless it is grief..then you often get more than wanted
Too many things going on to bother listing them.
pete
Posts: 2518
Joined: Tue Feb 10, 2009 6:04 am

Re: Jet 1236P

Post by pete »

LOL, you were reading my mind Bill. I know I've found a few extra options I for sure didn't think I was asking or even paying for. :-)
Post Reply