Rockwell 11" Metal Lathe Chuck removal tool

All discussion about lathes including but not limited to: South Bend, Hardinge, Logan, Monarch, Clausing and other HSM lathes, including imports

Moderators: GlennW, Harold_V

Post Reply
JoeVolcano
Posts: 14
Joined: Wed Dec 26, 2007 4:14 pm
Location: Santa Cruz

Rockwell 11" Metal Lathe Chuck removal tool

Post by JoeVolcano »

Hi All,

I am a new owner of a Rockwell 11" Metal Lathe, I have most of the various parts but realized I do not have a chuck removal tool.

Is there an owner of one of these lathes out there? Can I trouble you to take a picture of the tool next to a tape measure so I can fabricate one?

Thank you!

Geoff
-- JoeVolcano
User avatar
Bill Shields
Posts: 10459
Joined: Fri Dec 21, 2007 4:57 am
Location: 39.367, -75.765
Contact:

Re: Rockwell 11" Metal Lathe Chuck removal tool

Post by Bill Shields »

What type of chuck mount does it have?
Too many things going on to bother listing them.
whateg0
Posts: 1114
Joined: Sat Mar 28, 2009 3:54 pm
Location: Wichita, KS

Re: Rockwell 11" Metal Lathe Chuck removal tool

Post by whateg0 »

You just need a spanner. I don't recall the size but you can figure out the diameter by dividing the circumference by pi.
whateg0
Posts: 1114
Joined: Sat Mar 28, 2009 3:54 pm
Location: Wichita, KS

Re: Rockwell 11" Metal Lathe Chuck removal tool

Post by whateg0 »

Bill Shields wrote: Sun Nov 21, 2021 7:40 pm What type of chuck mount does it have?
The web says it's L00.
pete
Posts: 2518
Joined: Tue Feb 10, 2009 6:04 am

Re: Rockwell 11" Metal Lathe Chuck removal tool

Post by pete »

If it's L-00 this is what they look like. https://www.ebay.com/itm/254124219720
JoeVolcano
Posts: 14
Joined: Wed Dec 26, 2007 4:14 pm
Location: Santa Cruz

Re: Rockwell 11" Metal Lathe Chuck removal tool

Post by JoeVolcano »

Thank you!
-- JoeVolcano
Post Reply