Hi All,
I am a new owner of a Rockwell 11" Metal Lathe, I have most of the various parts but realized I do not have a chuck removal tool.
Is there an owner of one of these lathes out there? Can I trouble you to take a picture of the tool next to a tape measure so I can fabricate one?
Thank you!
Geoff
Rockwell 11" Metal Lathe Chuck removal tool
-
- Posts: 14
- Joined: Wed Dec 26, 2007 4:14 pm
- Location: Santa Cruz
Rockwell 11" Metal Lathe Chuck removal tool
-- JoeVolcano
- Bill Shields
- Posts: 10464
- Joined: Fri Dec 21, 2007 4:57 am
- Location: 39.367, -75.765
- Contact:
Re: Rockwell 11" Metal Lathe Chuck removal tool
What type of chuck mount does it have?
Too many things going on to bother listing them.
Re: Rockwell 11" Metal Lathe Chuck removal tool
You just need a spanner. I don't recall the size but you can figure out the diameter by dividing the circumference by pi.
Re: Rockwell 11" Metal Lathe Chuck removal tool
The web says it's L00.
Re: Rockwell 11" Metal Lathe Chuck removal tool
If it's L-00 this is what they look like. https://www.ebay.com/itm/254124219720
-
- Posts: 14
- Joined: Wed Dec 26, 2007 4:14 pm
- Location: Santa Cruz