I recently purchased a tail stock center (B821) that I hoped would work with my Motorized work head. However when I tried to pair it up with the work head is off center by a lot. It appears that this center is the left hand version,
but I have never see one like this in any of K O Lee brochures anywhere. Am I missing something here or what?
Skipd1
Alignment Issue with Cutter Grinder
Re: Alignment Issue with Cutter Grinder
I really feel stupid here, after a little research I realized that this center can be reversed and does align with the work head.
Sorry, my bad
skipd1
Sorry, my bad
skipd1
-
- Posts: 1955
- Joined: Wed Mar 15, 2006 11:10 pm
- Location: Farmington, NM
Re: Alignment Issue with Cutter Grinder
well, good that you found the solution.