WTB Southbend 10"collet holder so

[Randall Va]

Looking for 5c collet holder Thanks Randall

[Bill Shields]

They are a standard item that you can purchase from a variety of tool suppliers.

5 Morse taper on the outside. 5C collet inside.

[Randall Va]

Thanks Bill

[Bill Shields]

Shars or similar has them

[Richard_W]

I assume you are looking for 1 of these?

https://www.ebay.com/itm/164875258878?h ... Sw6s9fHo4t

Its been almost 50 years since I had a 10 inch South Bend lathe. I can't remember exactly, but the spindle took a 3C collet with out the use of an adapter. Which also allowed for a solid center to go into the spindle to turn between centers. So if memory serves me the adapter in the link is the way to go. But you will need a back plate to mount the collet chuck to your spindle.

Richard W.

[Bill Shields]

Ah...good point. My SB10 is a heavy 10

Not sure it makes a difference.

Know that the SB 9 machines are all 3C